Standard Guard Rail Assemblies (Safety Rail 2000 Standard Size Guard Rail)

Assembly: 10ft Assembly
Finish: Galvanized Rails and Bases (GB/GR)


SafetyRail 2000 Roof Guard Rail

Safety Rail 2000 is a non-penetrating, passive fall protection system for workplace safety that can be used from rooftop to ground level applications. Because they’re anchored by weighted baseplates rather than fastened down with bolts, these ballasted guard rails can be used as portable, permanent, or temporary roof edge protection solutions. Non-penetrating designs preserve the integrity of the roof system and make these solutions easy to install.

Please Note: Each assembly is sold as one whole set, consisting of Standard Rail 2000 Guard Rail Kits (please see options based on your need). All assemblies each contain two (2) 5ft Standard Rail 2000 Guard Rail Kits as outriggers, extra EPDM pads for extra protection, and an extra base. Each component rail kit already consists of a single base, two (2) locking pins, and a single-sized railing. Refer to the photos for sample guard rail assemblies.

Rail sections are constructed of 1-5/8" steel tubing and secure to 96-pound cast iron bases with four ports each, allowing for nearly infinite configurations. An extra base has already been added to each set, as it's needed at either the start or end of each run.

Basic Use:

The Safety Rail 2000 system creates an OSHA-compliant barrier for permanent or temporary roof edge protection installations. This design reduces costs and eliminates the danger of potential trip hazards presented by intermediate counterweights used in other guardrail systems. It provides a fully portable fall protection system for commercial, industrial, and worksite applications.

  • Can be used for permanent or temporary roof guard rail for roof edge protection
  • Quick and easy installation with no drilling needed
  • Deemed OSHA compliant by an independent accredited engineering firm
  • Available with "safety yellow" powder coat or galvanized finish
  • Optional EPDM rubber pads and BUR pads available for added roof surface protection

  • Compliant with OSHA regulations for guard rails: 29 CFR 1926.502
  • Structural Load: 200 lb. (90.7 kg), minimum, in any direction to all components
  • Height: 42” (106 cm)
  • Railings: 1-5/8” (4.1 cm) O.D. hot rolled picked electric weld tubing
  • Mounting Bases: Class 30 gray iron material cast with four receiver posts
  • Hardware: Securing pins shall be 1010 carbon steel, zinc plated, and yellow chromate dipped
Independent Test Results:

Safety Rail 2000 portable roof guard rail systems comply with OSHA regulations for permanent and temporary roof edge protection. Complete test results and wind load calculations are available upon request.

Freight Cost and Lead time:

Nationwide shipping costs are determined based on your order specifications. The minimum freight charge for a guardrail assembly is $350. For international shipping inquiries, please contact us at

Orders of more than 1 assembly require a freight quote. Please email for a quote that includes shipping costs. 

Lead Times may vary depending on order timing, as our guardrail system assemblies undergo meticulous assembly and quality checks. We'll reach out upon order placement with an estimated delivery timeframe. Alternatively, contact us before ordering for current lead times. Your satisfaction is our priority.

Supporting Documents for the SafetyRail 2000 Guardrail System:

SafetyRail2000 Product Data Sheet
SafetyRail2000 Standard Shop Drawing
SafetyRail2000 Guide Spec Word Doc Template - Download
Returns / Outrigger / Extra base guide sheet

For further inquiries or to place an order, please contact:

Dakota Safety
Phone: 866-503-7245
Address: 4155 S Robert Trl STE 2 St Paul MN 55123


Payment & Security

Discover Meta Pay Mastercard PayPal Shop Pay Venmo Visa

Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.

Estimate shipping

You may also like